The NEGATIVE LOCKING SYSTEM
(Requires 2 30amp relays)
Take the negative lock output
from the aftermarket unit to
pin 86 on a 30 amp relay
pin 87 goes to a solid chasis ground
pin 85, fuse at 10 amps
, put to a constant 12 volt source
pin 30, attatch to the
lock wire in your vehicle
pin 87A (middle) not used.
--------------------------
Take the negative unlock output
from the aftermarket unit to pin 86 on a 30 amp relay
pin 87 goes to a solid chasis ground
pin 85, fuse at 10 amps,
put to a constant 12 volt source
pin 30, attatch to the
unlock wire in your vehicle
pin 87A (middle) not used. DONE (SEE THE DIAGRAM)
------------------------------ POSITIVE LOCKING SYSTEM
(Requires 2 30amp relays)
Take the negative lock
output from the
aftermarket unit to
pin 86 on a 30 amp relay
pin 85, fuse at 10 amps,
put to a constant 12 volt source
pin 87, fuse at 10 amps,
put to a constant 12 volt source
pin 30, attatch to the
lock wire in your vehicle
pin 87A (middle) not used.
Take the negative unlock
output from the
aftermarket unit to
pin 86 on a 30 amp relay
pin 85, fuse at 10 amps,
put to a constant
12 volt source
pin 87, fuse at 10 amps,
put to a constant 12 volt source
pin 30, attatch to the
unlock wire in your vehicle
pin 87A (middle) not used. DONE (SEE THE DIAGRAM)
------------------------------------- THE 5 WIRE REVERSE DOOR LOCK SYSTEM
(Requires 2 30amp relays)
Locate the lock and
unlock wires in your vehicle
next, cut these two
wires in half. strip
off some of the covering from
the wires on all 4 exposed ends.
Take the negative lock output
wire from the aftermarket unit and attatch
it to PIN 86 on one relay.
Next attatch the motor
side of the cut lock wire to PIN 30.
Then attatch PIN 87A(middle)
To the switch side of the cut lock wire.
Lastly, BOTH PINs 87 and 85
are fused at 10 amps each,
and attatched to a
constant 12 volt source. -------------------------------------------
Take the negative unlock
output wire from the aftermarket unit
and attatch it to PIN 86 on the other relay.
Next attatch the motor side
of the cut unlock wire to PIN 30.
Then attatch PIN 87A(middle)
To the switch side
of the cut unlock wire.
Lastly, BOTH PINs 87 and
85 are fused at 10 amps each,
and attatched to a constant
12 volt source. DONE. (SEE THE DIAGRAM)
Make your own free website on Tripod.com